Figure 140: Line Card Connectors; Figure 141: Inserting A Line Card Into The Slot And Rotating The Handles - Juniper QFX10008 Hardware Manual

QFX10008 Switch Hardware Guide
226
CAUTION: Do not lift the line card by holding the edge connectors or the
handles on the faceplate. Neither the handles or the edge connectors can
support the weight of the line card. Lifting the line card by the handles or
edge connectors might bend them, which would prevent the line cards
from being properly seated in the chassis. See

Figure 140: Line Card Connectors

1— Connectors
Remove the line card from the electrostatic bag and inspect it for any damage before
3.
installing it into the chassis.
Grasp and lift the line card by the sides.
4.
Slide the line card all the way into the slot until the handle holes align. See
5.
Figure 141 on page 226.

Figure 141: Inserting a Line Card into the Slot and Rotating the Handles

Figure 140 on page 226.
Copyright © 2019, Juniper Networks, Inc.