Figure 63: Mounting Brackets For Four-Post Rack Installation - Juniper QFX10008 Hardware Manual

Copyright © 2019, Juniper Networks, Inc.
To install the mounting hardware in a four-post rack:
Remove the mounting brackets from the rack mount kit box.
1.
Decide where to place the chassis in the rack. If the rack is empty, mount the switch
2.
in the lowest possible location. See
Position the left base bracket at the desired position in the left side of the rack and
3.
line up its front screw holes with the holes in the rack. Use four mounting screws
appropriate for your rack to attach the left base bracket to the rack.
Position one of the rear brackets at the left rear of the rack on the same level as the
4.
left base bracket, so that the rear bracket overlaps with the left bracket. The screw
holes for connecting the base and rear brackets should overlap. Use four mounting
screws appropriate for your rack to attach the rear bracket to the rack.
Connect left base bracket and rear brackets (see
5.
Insert six of the screws provided with the mounting brackets into the overlapping
a.
bracket holes.
Hand-tighten the screws fully (to 12–16 in.-lb torque) using a number 2 Phillips
b.
screwdriver.

Figure 63: Mounting Brackets for Four-Post Rack Installation

1— Right and left base brackets
Position the right base bracket at the desired position in the right side of the rack
6.
opposite the installed left base bracket, so that it is on the same rack level as the left
Chapter 3: Initial Installation and Configuration
"QFX10000 Rack Requirements" on page
Figure 63 on page
2— Rear brackets
119.
151):
151