Figure 87: Esd Point For Qfx10008 Chassis Front; Figure 88: Esd Point For Qfx10016 Chassis Front; Figure 89: Removing A Rcb Cover Panel - Juniper QFX10008 Hardware Manual

Copyright © 2019, Juniper Networks, Inc.
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
1.
point on the front of the chassis (see

Figure 87: ESD Point for QFX10008 Chassis Front

1— ESD point

Figure 88: ESD Point for QFX10016 Chassis Front

Either remove the cover from the available RCB slot (see
2.
remove the failing RCB (see
page 177).

Figure 89: Removing a RCB Cover Panel

Remove the new RCB from the electrostatic bag and inspect it for any damage before
3.
installing it into the chassis.
Lift the RCB by its sides, being careful not to bump the connectors.
4.
Carefully align the sides of the RCB with the guides inside the chassis.
5.
Figure 87 on page 179
1
"Removing a QFX10000 Routing and Control Board" on
Chapter 4: Maintaining Components
and Figure 88 on page 179).
Figure 89 on page 179) or
179