Network Ports; Power And Status Leds; Table 29: Port Mapping For Channelization; Table 30: Power Led - Juniper QFX10008 Hardware Manual

Table 29: Port Mapping for Channelization

ASIC
PE0
PE1
PE2
PE3
PE4
PE5

Table 30: Power LED

Color State
Unlit Off
Green On steadily
Copyright © 2019, Juniper Networks, Inc.
CAUTION: Changing the channelization mode (mode D to mode A or mode
A to mode D) causes the FPC to reboot. Because there can be a slight loss
of data while the FPC reboots, we recommend that you only configure the
changes during a maintenance window.
Available Ports
0, 2, 4, 8
10, 12, 14, 18
20, 22, 24, 28
1, 3, 5, 9
11, 13, 15, 19
21, 23, 25, 29
To change from the default mode to 40-Gigabit Ethernet channelized mode, use the
Junos OS operational command set chassis fpc slot-number pic 0 port port number
channelization-speed 10g.

Network Ports

Each of the 30 QSFP28 ports supports:
100-Gigabit Ethernet using QSFP28 optical transceivers. When a QSFP28 transceiver
is inserted into any of the ports, the QSFP28 port is enabled for 100-Gigabit Ethernet.
40-Gigabit Ethernet using QSFP+ optical transceivers. When a QSFP+ transceiver is
inserted into any of the ports, the QSFP+ port is enabled for 40-Gigabit Ethernet.
QSFP+ to SFP+ direct attach copper breakout (DACBO) cables
On the QFX10000-30C-M, the ports are enabled by default, and the default configuration
adds the ports to the default VLAN.

Power and Status LEDs

The two LEDs to the left of the network ports indicate the power (
for the line card. See Table 30 on page 77
Description
There is no power to the line card.
The line card has power.
Disabled Port
6
16
26
7
17
27
PWR
and Table 31 on page 78.
Chapter 1: Overview
) and status ( STS )
77