Installing The Front Panel On A Qfx10000; Figure 68: Front Panel Mounting Hardware - Juniper QFX10008 Hardware Manual

Installing the Front Panel on a QFX10000

Copyright © 2019, Juniper Networks, Inc.
The front panel is required on the QFX10008 and QFX10016 to protect fiber optic cabling
and to provide additional protection from electromagnetic interference (EMI). The front
panel can be installed with or without the optional cable management system.
Ensure you have the following tools and parts before you begin:
A Phillips (+) screwdriver, number 2
Front panel (provided with the switch chassis)
Right base bracket (provided)
Left base bracket (provided)
2 interchangeable latch brackets (provided)
8 Phillips flat-head mounting screws (provided)
To install the front panel:
Remove the plastic bag that is taped to the front panel, which holds the brackets and
1.
screws.
Use the Phillips screwdriver to attach two mounting screws to the left base bracket
2.
at the bottom left side of the chassis frame. The base brackets are larger than the
latch brackets.
NOTE: The right and left base bracket cannot be interchanged (see
Figure 68 on page

Figure 68: Front Panel Mounting Hardware

3
1— Latch brackets
2—Right base bracket
Use the Phillips screwdriver to attach two mounting screws to the right base bracket
3.
at the bottom right side of the chassis frame.
Chapter 3: Initial Installation and Configuration
159).
1
2
3— Left base bracket
159