Copyright © 2019, Juniper Networks, Inc.
seated in the slot. Ensure the power supply faceplate is flush with any adjacent power
supply faceplates or power supply cover panels (see
Push the captive screw into the power supply faceplate. Ensure that the screw is
16.
seated inside the corresponding hole on the faceplate.
Tighten the captive screw by turning it clockwise by using the Phillips (+) screwdriver,
17.
number 1. When the screw is completely tight, the latch locks into the switch chassis.
Chapter 4: Maintaining Components
Figure 120 on page
208).
207