QFX10008 Switch Hardware Guide
Installing a QFX10008 Fan Tray
182
Grasp the top and bottom handles and pull the fan tray out about 3 in. (7.6 cm). See
3.
Figure 92 on page
182.
Figure 92: Removing a Fan Tray from a QFX10008 Chassis
FAN FTC
SIB STATUS
FAN FTC
SIB STATUS
Tilt the top of the fan tray forward.
4.
Using both hands, lift the fan tray out of the slot and rest it on a flat surface with the
5.
handles to the side.
CAUTION:
Replace a fan tray within three minutes to avoid chassis
overheating.
The QFX10008 chassis has two independent, field-replaceable fan trays. Each fan tray
is a hot-removable and hot-insertable field-replaceable unit (FRU); you can remove and
replace the fan tray while the switch is running without turning off power to the switch
or disrupting switching functions.
Before you begin to install a fan tray:
Copyright © 2019, Juniper Networks, Inc.