Figure 107: Installing An Ac Power Supply In A Qfx10008 - Juniper QFX10008 Hardware Manual

QFX10008 Switch Hardware Guide
194
Rotate the captive screw away from the faceplate of the power supply to release the
7.
latch.
NOTE: You can install the power supplies in any slot labeled
PSU 5 (top to bottom) on a QFX10008, and
QFX10016.
Using both hands, place the power supply in the power supply slot on the rear of the
8.
system. Slide the power supply straight into the chassis until the power supply is fully
seated in the slot. Ensure the power supply faceplate is flush with any adjacent power
supply faceplates or power supply covers (see
Figure 108 on page 195).
Push the captive screw into the power supply faceplate. Ensure that the screw is
9.
seated inside the corresponding hole on the faceplate.
Tighten the captive screw by turning it clockwise by using the Phillips (+) screwdriver,
10.
number 1. When the screw is completely tight, the latch locks into the switch chassis.

Figure 107: Installing an AC Power Supply in a QFX10008

Keep latch in open position during installation.
PSU 0
PSU 0 through PSU 9
Figure 107 on page 194 and
Copyright © 2019, Juniper Networks, Inc.
through
on a