Figure 117: Connecting The Dc Power Supply Cables To A Qfx10000 - Juniper QFX10008 Hardware Manual

Copyright © 2019, Juniper Networks, Inc.

Figure 117: Connecting the DC Power Supply Cables to a QFX10000

Install the plastic cable cover over each set of power cables by using the
11.
Phillips (+) screwdriver, number 2, to tighten the screw.
If the power supply slot on the chassis has a cover panel on it, insert your thumb and
12.
forefinger into the finger holes, squeeze, and pull the cover out of the slot. Save the
cover for later use (see
Figure 119 on page 206
Figure 118 on page 206 for QFX10008 installations and
for QFX10016 installations).
Chapter 4: Maintaining Components
205