Figure 99: Esd Point On Qfx10008 Chassis Rear; Figure 100: Esd Point On Qfx10016 Chassis Rear - Juniper QFX10008 Hardware Manual

Copyright © 2019, Juniper Networks, Inc.
Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and
1.
connect the strap to the ESD point on the chassis. There is an ESD point located next
to the protective earthing terminal and below
Figure 99 on page 189) and below

Figure 99: ESD Point on QFX10008 Chassis Rear

1— ESD point

Figure 100: ESD Point on QFX10016 Chassis Rear

1— ESD point
Flip the switch next to the appliance inlet on the power supply to the standby
2. Enable
position.
Disconnect power from the switch by performing one of the two following tasks:
3.
If the AC power source outlets have a power switch, set them to the OFF position.
If the AC power source outlets do not have a power switch, gently pull the male end
of the power cords connected to the power source outlets out of the outlets.
Remove the power cords from the AC appliance inlets on the AC power supply
4.
faceplate.
Chapter 4: Maintaining Components
on the QFX10008 rear panel (see
PSU 5
on the QFX10016 (see
PSU_9
Figure 100 on page 189).
189