Figure 118: Removing The Psu Cover On A Qfx10008; Figure 119: Removing The Psu Cover On A Qfx10016 - Juniper QFX10008 Hardware Manual

QFX10008 Switch Hardware Guide
206

Figure 118: Removing the PSU Cover on a QFX10008

Figure 119: Removing the PSU Cover on a QFX10016

Unscrew the captive screw in the counterclockwise direction by using the
13.
Phillips (+) screwdriver, number 1.
Pull the captive screw away from the faceplate of the power supply to release the
14.
latch.
NOTE: You can install the power supplies in any slot labeled
(top to bottom) on a QFX10008 and
PSU 5
QFX10016.
Using both hands, place the power supply in the power supply slot on the rear of the
15.
switch. Slide the power supply straight into the chassis until the power supply is fully
PSU 0 through
through on a
PSU 0 PSU 9
Copyright © 2019, Juniper Networks, Inc.