Unpacking And Mounting The Ex4300 Switch; Unpacking An Ex4300 Switch - Juniper EX4300 Series Hardware Manual

Unpacking and Mounting the EX4300 Switch

IN THIS SECTION
Unpacking an EX4300 Switch | 166
Parts Inventory (Packing List) for an EX4300 Switch | 167
Register Products-Mandatory to Validate SLAs | 169
Installing and Connecting an EX4300 Switch | 170
Mounting an EX4300 Switch | 171
Mounting an EX4300 Switch on Two Posts of a Rack or Cabinet | 172
Mounting an EX4300 Switch on Four Posts of a Rack or Cabinet | 176
Mounting an EX4300 Switch in a Recessed Position in a Rack or Cabinet | 179
Mounting an EX4300 Switch on a Wall | 180

Unpacking an EX4300 Switch

EX4300 switches are shipped in a cardboard carton, secured with foam packing material. The carton has
an accessory compartment.
CAUTION: EX4300 switches are maximally protected inside the shipping carton. Do
not unpack the switches until you are ready to begin installation.
To unpack the switch:
1. Move the shipping carton to a staging area as close to the installation site as possible, but where you
have enough room to remove the system components.
2. Position the carton so that the arrows are pointing up.
3. Open the top flaps on the shipping carton.
4. Pull out the packing material holding the switch in place.
5. Verify the parts received against the inventory on the label attached to the carton. See
Inventory (Packing List) for an EX4300 Switch" on page
6. Save the shipping carton and packing materials in case you need to move or ship the switch later.
167.
166
"Parts