Figure 147: Esd Point On Qfx10008 Chassis Front; Figure 148: Esd Point On Qfx10016 Chassis Front; Figure 149: Removing The Sata Ssd - Juniper QFX10008 Hardware Manual

Copyright © 2019, Juniper Networks, Inc.
To remove either size of SATA SSD in a QFX10000:
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
1.
point on the chassis. There is an ESD point located above the status LED panel on the
right side of the switch chassis (see

Figure 147: ESD Point on QFX10008 Chassis Front

Figure 148: ESD Point on QFX10016 Chassis Front

1— ESD point
Loosen the two captive screws of the SATA SSD on the control panel by using the
2.
Phillips (+) screwdriver, number 1.
Grasp the faceplate of the SATA SSD by the captive screws and slide the drive out of
3.
the control panel (see Figure 149 on page

Figure 149: Removing the SATA SSD

Place the SATA SSD in an electrostatic bag or on an antistatic mat.
4.
Replace the drive with either a new SATA SSD or with a slot cover.
5.
Chapter 4: Maintaining Components
Figure 147 on page 231 and
1
231).
Figure 148 on page 231).
231