Juniper QFX10008 Hardware Manual page 252

QFX10008 Switch Hardware Guide
252
Table 68: Chassis Component Alarm Conditions on QFX10000 Modular
Models (continued)
Chassis
Component Alarm Condition
Ethernet The Ethernet
management interface
on the Control board is
down.
Hot Too many hot-swap
interrupts are occurring.
swapping
Power A power supply has been
removed from the
supplies
chassis.
A power supply has a
high temperature.
A power supply input has
failed.
A power supply output
has failed.
A power supply has
failed.
AC and DC power
supplies are installed.
Inadequate number of
power supplies.
Alarm
Severity Remedy
Minor Check the interface cable
(yellow) connection.
Reboot the system.
If the alarm recurs, open a support
case using the Case Manager link at
https://www.juniper.net/support/
or call 1-888-314-5822 (toll free, US
& Canada) or 1-408-745-9500
(from outside the United States).
Major Replace the failed components.
(red)
Minor Install a power supply in the empty
(yellow) slot.
Major Replace the failed power supply.
(red)
Major Check power supply input connection
(red) and the power cord.
Major Check power supply output
(red) connection.
Major Replace the failed power supply.
(red)
Major Do not mix AC and DC power supplies.
(red)
Major Install an additional power supply.
(red)
Copyright © 2019, Juniper Networks, Inc.