Switch Ports; Figure 41: Qfx10000-36Q Port Panel - Juniper QFX10008 Hardware Manual

QFX10008 Switch Hardware Guide
80
that can be installed in the line card slots on the front of the switch chassis. The line cards
are hot-insertable and hot-removable; you can remove and replace them without
powering off the switch or disrupting switch functions. See

Figure 41: QFX10000-36Q Port Panel

1— Status and activity LEDs
Each QSFP28 socket can be configured to support:
100-Gigabit Ethernet using QSFP28 optical transceivers. When a QSFP28 transceiver
is inserted into the ports marked with a fine black line underneath the socket and the
port is configured for 100-Gigabit Ethernet, the two adjacent ports are disabled and
the QSFP28 socket is enabled for 100-Gigabit Ethernet.
40-Gigabit Ethernet using QSFP+ optical transceivers.
10-Gigabit Ethernet using breakout cabling and attached optical transceivers. When
configured for channelization, the system converts the 40-Gigabit Ethernet port into
4 independent 10-Gigabit Ethernet ports.
Any of the 36 ports 0 through

Switch Ports

Each of the 12 QSFP28 ports supports:
100-Gigabit Ethernet QSFP28 transceivers
40-Gigabit Ethernet QSFP+ transceivers
QSFP28 direct attach copper (DAC) cables
QSFP+ DAC cables
QSFP+ to SFP+ direct attach copper breakout (DACBO) cables
Each of the 36 QSFP+ ports supports:
40-Gigabit Ethernet QSFP+ transceivers
QSFP+ DAC cables
QSFP+ to SFP+ fiber breakout and DACBO cables
Access ports
You can use 40-Gigabit Ethernet QSFP+ transceivers and QSFP+ DAC cablesin any
downstream port. See "QFX10000 Optical Transceiver and Cable Support" on page
Uplink ports
2— Network ports
35 can be configured as either uplink or access ports.
Copyright © 2019, Juniper Networks, Inc.
Figure 41 on page 80.
130.