Page 174 of 302
Replace an i2004 Internet Telephone
Remove an i2004 Internet Telephone from service
i2004 Internet Telephone maintenance and diagnostics
553-3001-204 Preliminary 0.10 August 2000
Installation and maintenance of i2004 Internet Telephone
3
Press the "Clear" softkey during the five-second period. The existing
node and TN will be cleared.
4
The i2004 Internet Telephone prompts the user for new Node Number
and TN information.
—————————— End of Procedure ——————————
Procedure 28
Replacing an i2004 Internet Telephone
1
Use the Manual or Automatic first-time installation procedures,
Procedures 25 and 26, described in this chapter to install and
configure the i2004 Internet Telephone.
2
Enter the same TN and Node Number as the i2004 Internet Telephone
you replaced. Meridian 1 ITG gateway associates the new i2004
Internet Telephone with the existing TN.
—————————— End of Procedure ——————————
Procedure 29
Taking an i2004 Internet telephone out of service
1
Disconnect the i2004 Internet Telephone from the network or turn the
power off.
2
If the i2004 Internet Telephone was automatically configured, the
DHCP lease will expire and the IP address returns to the available
pool.
3
In Overlay 11, OUT the TN.
—————————— End of Procedure ——————————
In the i2004 Internet Telephone, there are two kinds of TNs to consider:
•
Physical TN, which represents a physical unit of the ITG card
•
Virtual TN, which is configured on a virtual superloop and represents an
i2004 Internet Telephone