Configuring Ip Line Data; Configuring Ip Line Data With Otm 2.1 - Nortel Meridian 1 Succession 1000M Installation And Configuration Manual

Page 326 of 562

Configuring IP Line data

Configuring IP Line data with OTM 2.1

553-3011-210 Standard 1.00
IP Line card configuration
PRT ELNK
6 Activate New Host entry. Enter the following command:
CHG ELNK ACTIVE <hostname> <cab#>
Where:
<cab#> = 1–4 for IP expansion cabinets or chassis
7 Update the ELAN configuration. Enter the following command:
UPDATE DBS
8 Reboot the main cabinet for the changes to take effect or go into LD 137
and disable and enable the ELNK. Enter the following commands:
DIS ELNK
ENL ELNK
IP Line data can be configured in OTM or Element Manager.
Refer to IP Line: Description, Installation and Operation (553-3001-365)
and Internet Terminals (553-3001-368) for a detailed description of the
procedures listed below.
1 Manually add an IP Telephony node. Do not use this node anywhere else.
It is unique for this cabinet or chassis.
2 Configure the card properties of the Voice Gateway Media Card.
3 Configure DSP Profile data.
4 Configure SNMP traps and ELAN gateway routing table.
October 2003
End of Procedure