Ip Configuration Commands; Download The Itg Error Log; Lamp Audit And Keep Alive - Nortel Meridian ITG Line 2.0 Description, Installation And Operation Manual

Page 202 of 302

IP configuration commands

Table 4
IP configuration commands
IP configuration command
setLeader
clearLeader
NVRIPShow

Download the ITG error log

Lamp audit and keep alive

553-3001-204 Preliminary 0.10 August 2000
ITG line card 2.0 administration
Performs all the necessary actions to make a leader.
Sets IP address, gateway, subnet mask, boot method to
static, and leader bit in NVRAM.
Clears the leader info in NVRAM and sets the boot
method to use bootp, thus, making the card a follower:
Prints the values of the IP parameters that reside in
NVRAM.
The ITG error log contains error conditions as well as normal events. Some
of the error conditions cab be severe enough to raise an alarm through SNMP
traps.
The following commands are used to download an ITG error log:
• currLogFilePut
• prevLogFilePut
The Meridian 1 Lamp Audit function provides a continuous source of
heartbeat messages to ensure the i2004 Internet Telephone is powered and the
IP connection is alive. Since there is a reliable UDP connection from the
Meridian 1 core through to the i2004 Internet Telephone, any failure of the
i2004 Internet Telephone, the ITG card or the IP connection is detected.
You can run Network Signaling diagnostics as part of the midnight routines.
Function