Parameter Setup Edit Interface; State Monitoring Interface - Kruger Ecowatt K320 Series Operation Manual

Ecowatt Drive K320 series
®

5.4.6 Parameter setup edit interface

In the fourth-level menu in "parameter setup" menu, press
enter parameter setup edit interface. After entering edit interface, set the parameter from low
bit to high bit, and the bit under setting will be highlighted. Press
increase or decrease the parameter value (this operation is valid until the parameter value
exceeds the max. value or min. value); press
are set, press
parameter. In parameter setup edit interface, press
value and return to the previous menu.
16:02:35 Forward Local Ready
P00.00: Speed control mode
P00.01: Running command channel
P00.02: Communication command channel
P00.03: Max. output frequency
P00.04: Upper limit of running frequency
P00.05: Lower limit of running frequency
Return Add
In parameter selection edit interface, the "authority" on the top right indicates whether this
parameter can be modified or not.
"√" indicates the set value of this parameter can be modified under current state.
"×" indicates the set value of this parameter cannot be modified under current state.
"Current value" indicates the value saved last time.
"Default value" indicates the default value of this parameter.

5.4.7 State monitoring interface

In the fourth-level menu of "state monitoring/fault record" menu, press
key to enter state monitoring interface. After entering state monitoring interface, the
current parameter value will be displayed in real time, this value is the actually detected value
which cannot be modified. In state monitoring interface, press
return to the previous menu.
16:02:35
Forward
P17.00：Set frequency
P17.01: Output frequency
P17.02: Ramps reference frequency
P17.03: Output voltage
P17.04: Output current
P17.05: Motor speed
Return
key or key to save the set parameters and return to the previous
01: K320
Current value：50.00
Max. output frequency
Max. value: 630.00
Min. value: 50.00
Default value: 50.00
Return
Select
Figure 5-16 Parameter setup edit interface
Local Ready 01: K320
Add
Select
Figure 5-17 State monitoring interface
or to shift the edit bit. After parameters
to maintain the original parameter
Authority: √
Hz
050.00
Homepage
Confirm
16:02:35 Forward
Setting frequency
Max. value: 630.00
Min. value: 0.0
Default value: 0.0
Return
-44-
Basic operation guidelines
key, key or
key or
Current value：50.00
Max. output frequency
050.01
Max. value: 630.00
Min. value: 50.00
Default value: 50.00
Return Homepage
key,
key or
Local Ready 01: K320
Hz
50.00
Homepage
Confirm
key to
key to
Authority: √
Hz
Confirm
key or
key to