Displaying Running-State Parameters; Displaying Fault Information - Kruger Ecowatt K320 Series Operation Manual

Ecowatt Drive K320 series
®

5.3.2 Displaying running-state parameters

After receiving valid running command, the VFD will enter running state, and the keypad
displays running state parameter with RUN indicator on the keypad turning on. Under
running state, multiple kinds of state parameters can be displayed. Press
up or down.
16:02:35 Forward
Output frequency
P17.01 Hz
Set frequency
P17.00 Hz
DC bus voltage
P17.11 V
Monitoring
Press or to switch between different display styles, including list display style and
progress bar display style.
16:02:35 Forward
DC bus voltage
P17.11 V
Digital input terminal state
P17.12
Digital output terminal state
P17.13
Monitoring
Under running state, multiple kinds of state parameters can be displayed. The running display
parameter list is defined by the user, and each state variable function code can be added to the
running display parameter list as needed. The state variable which has been added to the
running display parameter list can also be deleted or shifted.

5.3.3 Displaying fault information

The VFD enters fault alarm display state once fault signal is detected, and the keypad displays
fault code and fault information with TRIP indicator on the keypad turning on. Fault reset
operation can be carried out via STOP/RST key, control terminal or communication command.
The fault code will be kept displaying until fault is removed.
Local Run 01: K320
50.00
50.00
540.0
About
Menu
Figure 5-5 Running state parameters
Local Ready 01: K320
540.00
0x0000
0x0000
About
Menu
Figure 5-6 Displaying a running state parameter
16:02:35 Forward
Set frequency
P17.00 Hz
DC bus voltage
P17.11 V
Output voltage
P17.03 V
Monitoring
16:02:35
DC bus voltage
V
0.0
Return
-35-
Basic operation guidelines
or
Local Run 01: K320
50.00
540.0
378
About
Forward Local Ready
540.00
Homepage
to shift
Menu
01: K320
2000.0