Function Parameter List - Kruger Ecowatt Drive K120 Series Operation Manual

Ecowatt ® Drive K120 series

Function parameter list

5 Function parameter list
The function parameters of K120 series VFD have been divided into 30 groups (P00–P29)
according to the function, of which P18–P28 are reserved. Each function group contains
certain function codes. A three-level menu style is applied to function codes. For
example, "P08.08" indicates the 8th function code in the P8 group. The P29 group
consist of factory function parameters, which are user inaccessible.
The function group numbers correspond to the level-1 menus, the function codes
correspond to the level-2 menus, and the function parameters correspond to the level-3
menus.
1. The content of the function code table is as follows:
Column 1 "Function code ": Code of the function group and parameter.
Column 2 "Name": Full name of the function parameter.
Column 3 "Description": Detailed description of the function parameter.
Column 4 "Default": Initial value set in factory.
Column 5 "Modify": Whether the function parameter can be modified, and conditions
for the modification.
"○" indicates that the value of the parameter can be modified when the VFD is in
stopped or running state.
"◎" indicates that the value of the parameter cannot be modified when the VFD is in
running state.
"●" indicates that the value of the parameter is detected and recorded, and cannot be
modified.
(The VFD automatically checks and constrains the modification of parameters, which
helps prevent incorrect modifications.)
2. The parameters adopt the decimal system (DEC). If the hexadecimal system is
adopted, the data in each digit is independent from each other during parameter editing.
The values of some of the digits can be hexadecimal (0–F).
3. "Default" indicates the factory setting of the function parameter. If the value of the
parameter is detected or recorded, the value cannot be restored to the factory setting.
4. To better protect parameters, the VFD provides the password protection function.
After a password is set (that is, P07.00 is set to a non-zero value), "0.0.0.0.0" is displayed
when you press the PRG/ESC key to enter the function code editing interface. You need
to enter the correct user password to enter the interface. For the factory parameters, you
need to enter the correct factory password to enter the interface. (You are not advised to
-30-