Kruger Ecowatt K320 Series Operation Manual page 106

Ecowatt Drive K320 series
®
Setting Function
21 ACC/DEC time selection 1 The two terminals are used to select four groups of
22 ACC/DEC time selection 2
23 Simple PLC stop reset
24 Pause simple PLC
25 Pause PID control
Pause wobbling
26 frequency (stopped at the
current frequency)
Reset wobbling
27 frequency (back to the
central frequency)
28 Counter reset
Switch between speed
29 control and torque
30 Disable ACC/DEC
31 Trigger the counter
Clear the frequency
33 increase/decrease setting
temporarily
34 DC braking
acceleration/decoration time. (T indicates Terminal in
the following table.)
Used to restart simple PLC process and clear previous
PLC state information.
The program pauses during PLC execution, and keeps
running in present speed step. After this function is
cancelled, simple PLC keeps running.
PID is ineffective temporarily, and the VFD maintains
present frequency output.
The VFD pauses at current output. After this function is
canceled, it continues wobbling-frequency operation at
current frequency.
The set frequency of VFD returns to the center
frequency.
The counter is cleared.
The VFD switches from torque control mode to speed
control mode, or vice versa.
control
Used to ensure the VFD is not be impacted by external
signals (except for stop command), and the VFD
maintains the present output frequency.
Used to enable the counter to cunt pulses.
When the terminal is closed, the frequency value set by
UP/DOWN can be cleared to restore the reference
frequency to the frequency given by frequency
command channel; when terminal is disconnected, it
will revert to the frequency value after frequency
increase/decrease setting.
The VFD immediately starts DC braking once after the
command is valid.
Description
T1 T2 ACC/DEC time
OFF OFF ACC/DEC time 1
ON OFF ACC/DEC time 2
OFF ON ACC/DEC time 3
ON ON ACC/DEC time 4
-97-
Basic operation guidelines
Parameter
P00.11/P00.12
P08.00/P08.01
P08.02/P08.03
P08.04/P08.05