Kruger Ecowatt K320 Series Operation Manual page 206

Ecowatt Drive K320 series
®
Function
Name
code
ACC/DEC time of
P10.34 steps 0–7 of
simple PLC
ACC/DEC time of
P10.35 steps 8–15 of
simple PLC
P10.36 PLC restart mode
Description
The description is as follows (St indicates
step):
Code Binary
BIT1 BIT0 0 00
BIT3 BIT2 1
BIT5 BIT4 2
BIT7 BIT6 3
P10.34
BIT9 BIT8 4 00
BIT11 BIT10 5
BIT13 BIT12 6
BIT15 BIT14 7
BIT1 BIT0 8
BIT3 BIT2 9 00
BIT5 BIT4 10 00
BIT7 BIT6 11 00
P10.35
BIT9 BIT8 12 00
BIT11 BIT10 13 00
BIT13 BIT12 14 00
BIT15 BIT14 15 00
Select corresponding ACC/DEC time, and
then convert 16-bit binary number into
hexadecimal number, finally, and then set
corresponding function codes.
ACC/DEC time 1 is set by P00.11 and P00.12;
ACC/DEC time 2 is set by P08.00 and
P08.01; ACC/DEC time 3 is set by P08.02
and P08.03; Acceleration /deceleration
time 4 is set by P08.04 and P08.05.
Setting range:0x0000–0xFFFF
0: Restart from the first step, namely if the
VFD stops during running (caused by stop
command, fault or power down), it will
-197-
ACC/ ACC/ ACC/ ACC/
St DEC DEC DEC DEC
T1 T 2 T3 T4
01 10 11
00 01 10 11
00 01 10 11
00 01 10 11
01 10 11
00 01 10 11
00 01 10 11
00 01 10 11
00 01 10 11
01 10 11
01 10 11
01 10 11
01 10 11
01 10 11
01 10 11
01 10 11
Function parameter list
Default Modify
0x0000
○
0x0000
○
0
◎