Kruger Ecowatt K320 Series Quick Manual

Ecowatt
®
Quick Setting Manual
OVERVIEW: This is a basic installation and commissioning steps that must be adhere for quick installation and commissioning.
STEP 1 - UNPACK INSPECTION
Check the following after receiving the product. If found
abnormalities, please contact the local dealer or Kruger office.
1.1 Check if the packing box is damaged.
1.2 Check if the interior surface of the packing box is abnormal.
For example, in wet condition or whether the enclosure of the
VFD is damaged or cracked.
1.3 Check if the accessories inside the packing box are complete
(including the manual and keypad).
1.4 Check if the VFD nameplate is consistent with the model
identifier on the exterior surface of the packing box and your
purchased model.
Model: K320-004P-4
Power: 4.0kW
Input: AC 3PH 380(-15%)~400V(+15%) 13.5A
47Hz~63Hz
Output: AC 3PH 0-Uinput 9.5A 0-400Hz
S/N:
Kruger Ventilation Industries Asia Co., Ltd.
Drive K320 Series
STEP 2 - INSTALLATION CONFIRMATION
Check the following before VFD installation.
2.1 Ensure that the grid voltage meets input power of VFD.
2.2 Ensure that the output power from VFD is matched with the
motor spec.
2.3 Ensure that the environments of installation area are not over
the VFD specified limits.
LCD keypad
Standard
Power supply
Breaker
P1
IP20
+
DC reactor
Input reactor
Earth
Input filter
Made in China
2.6 Ensure that all grounding systems are properly grounded
according to the requirements of the VFD.
2.7 Ensure that the external connection terminals of the VFD are
tightly fastened and the torque on the bolts are appropriate.
2.8 Ensure that there are screws, cables, or other conductive
items are cleared from the VFD. If no, clear them out.
Check the following after the
Upper PC
VFD installation.
software
RS485–
485+
2.4 Ensure that the correct
RS232
converter
485-
PC
accessories are selected for
the VFD. The accessories
-
PB + +
are correct and properly
installed, and the
installation cables meet the
requirements of all
components (including the
Brake
resistor reactor, input filter, output
Brake unit
reactor, output filter, DC
reactor, braking unit and
Output filter
braking resistor).
2.5 Ensure that all control
Output reactor
cables and power cables are
Motor
run separately and the
routing complies with EMC
Earth
requirements.
1/2
STEP 3 - BASIC COMMISSIONING
Complete the basic commissioning below before the actual use
of the VFD. (See more details in page no. 2)
3.1 MOTOR SETTING
& AUTO TUNING
3.2 CONTROL
METHOD & SETTING
CAUTION: The K320 should ONLY be installed by a
qualified electrician.
DANGER! Improper wiring can and will cause bodily
harm as well as damage to the equipment.