Installation Mode - Kruger Ecowatt K320 Series Operation Manual

Ecowatt Drive K320 series
®
OK
A. Vertical installation

4.2.3 Installation mode

There are three kinds of installation modes based on different VFD dimensions.
Wall-mounting: suitable for 355P and lower models

Flange-mounting: suitable for 220P and lower models

Floor-mounting: suitable for 250P–500P models

(1) Mark the position of the installation hole. See appendix for the position of installation hole;
(2) Mount the screws or bolts onto the designated position;
(3) Put the VFD on the wall;
(4) Tighten the fixing screws on the wall.
Note:
The flange-mounting plate is a must for 2R2P–090P models that adopt flange-mounting

mode; while 110P–220P models need no flange-mounting plate.
The installation base is optional for 250P–355P models. The base can hold an input AC

reactor (or DC reactor) and an output AC reactor.
NG
B. Horizontal installation
Figure 4-1 Installation direction of the VFD
Wall-mounting
Figure 4-2 Installation mode
C. Transverse installation
Flange-mounting
-17-
Installation guidelines
NG