Kruger Ecowatt K320 Series Operation Manual page 113

Ecowatt Drive K320 series
®
Setting
3 In reverse running
4
5
6 Frequency level detection FDT1
7 Frequency level detection FDT2 Refer to P08.34 and P08.35.
8 Frequency reached
9 Running in zero speed
10 Reach upper limit frequency
11 Reach lower limit frequency
12
13
14 Overload pre-alarm
15 Underload pre-alarm
16 Simple PLC state completed
Simple PLC cycle completed
17
Virtual terminal output of
23 Modbus/Modbus TCP
Virtual terminal output of
POROFIBUS/CANopen/DeviceNET
24
Function
In jogging
VFD fault
Ready to run
In pre-exciting
communication
communication
Description
Output ON signal when there is frequency
output during reverse running
Output ON signal when there is frequency
output during jogging
Output ON signal when VFD fault occurred
Refer to P08.32 and P08.33.
Refer to P08.36.
Output ON signal when the VFD output
frequency and reference frequency are both
zero.
Output ON signal when the running frequency
reaches upper limit frequency
Output ON signal when the running frequency
reached lower limit frequency
Main circuit and control circuit powers are
established, the protection functions do not
act; when the VFD is ready to run, output ON
signal.
Output ON signal during pre-exciting of the
VFD
Output ON signal after the pre-alarm time
elapsed based on the pre-alarm threshold; see
P11.08–P11.10 for details.
Output ON signal after the pre-alarm time
elapsed based on the pre-alarm threshold; see
P11.11–P11.12 for details.
Output signal when current stage of simple
PLC is completed
Output signal when a single cycle of simple
PLC operation is completed
Output corresponding signal based on the set
value of Modbus/Modbus TCP; output ON
signal when it is set to 1, output OFF signal
when it is set to 0
Output corresponding signal based on the set
value of PROFIBUS\CANopen; output ON signal
when it is set to 1, output OFF signal when it is
set to 0
-104-
Basic operation guidelines