Nortel DMS-100 Series Maintenance Manual page 547

Replacing a card
At the STAR or RLD
1 Proceed only if you have been directed to this procedure from a step in a
maintenance procedure. Using this procedure independently may cause
equipment damage or loss of service.
2
Remove any cables from the faceplate of the card to be replaced and note the
connector numbers.
3 Locate the card to be removed on the appropriate shelf if you have not
already done so.
Star Remote System card replacement procedures
DANGER
Static electricity damage
Wear a wrist strap connected to the wrist strap grounding
point on the frame supervisory panel (FSP) while handling
cards. This precaution protects the cards against damage
caused by static electricity.
DMS-100 Family NA100 Star Remote System XPM15 and up
Replacing a card
STAR or RLD
(continued)
12-199