Scan Points And Distribution Points (Scsd) Test Tool For Rld/Hub; Pm Level User Interface - Nortel DMS-100 Series Maintenance Manual

Table 6-2 Usage examples for QLEN command
Description of task:
Command:
MAP response

Scan points and distribution points (SCSD) test tool for RLD/HUB

A test tool called STARSCSD is available to test the SC and SD points that
reside in the NTTR70AA Star Module Controller (SMC) in the Star Module.
The scan points report alarms to the SMC. The distribution points activate
environmental components to control temperature conditions in the outside
plant cabinet. The tool's commands are:
•
•
•
•
•
•

PM level user interface

The PM (peripheral module) level directories and commands presented in this
section are used to monitor and perform maintenance on the Star Hub.
HELP - to list the commands supported by the program.
SET - set ON single/all points or function in a SD-group.
RESET - set OFF single/all points or function in a SD-group.
READ - get a single/all points or function of a SC-group.
TEST - this command has several subcommands:
— SDONSET - set a single SD-point ON.
— SDOFSET - set single SD-point OFF.
— SETSD - set a SD-group to a 'masked' state map.
— GETSC - read the state of SC-group (all points).
— SCSMON - set a monitor on 'masked' state map (for SC-groups) to be
in the selected state, for X time, in Y time frame.
LEAVE - to exit the program.
DMS-100 Family NA100 Star Remote System XPM15 and up
Star Remote System user interface 6-5
Query the LEN " ARPT 4 3 6 0"
QLEN ARPT 4 3 6 0
-----------------------------------------------
LEN: APRT 04 03 06 00
RLD LINE LOCATION:AIRPORT
HUB SITE: LORN
TYPE: SINGLE PARTY LINE
SNPA: 613
. . . .
SITE:ARPT