Nortel DMS-100 Series Maintenance Manual page 483

SysB
PM
STAR
STAR REM1 00 0 ISTb
Unit 0: ISTb
Unit 1: ManB
Drwr: 11 11 11 11 11 22 22 22 22 22 33 33 33
01 23 45 67 89 01 23 45 67 89 01 23 45 67 89 01 23 45
MM .M -- -- -- -- -- -o ss -- -- -- -- -- -- -- -- --
REM9 RLD DRWR 8 SYSB
BANK_0: Active
BANK_1: Stby
5 To busy the posted RLD, type
>BSY DRWR
and press the Enter key.
Example of a MAP display:
Warning:
Do you wish to continue?
Please confirm ("YES", "Y", "NO", "N")
6 To respond affirmatively to the confirmation request, type
>Y
and press the Enter key.
At the SRME or SRMO site
7 The type of enclosure the Star Module has determines your next action.
If the RLD is in an
SRME (inside) wall mount
SRMO (outdoors) cabinet
8 Use a slot screwdriver and turn the 1/4-turn screws at the bottom of the cover.
Hold the cover by the left and right sides, lift up, and pull the cover towards
you. Set the cover out of the way. Pull the interlock switch out to silence the
door alarm at the MAP terminal. Go to step 11.
9 Unlock and open the cabinet door. The door alarm generates a Major alarm
at the MAP terminal. Silence the alarm by pulling the interlock switch out.
Loosen the two large screws at the left side of the inside TSS cover. Open
the TSS cover to access the TSS. Pull the interlock switch out to silence the
door alarm at the MAP terminal.
10 Power down the RLD by performing the following steps:
a Set the circuit breaker on the dc panel to OFF.
Star Remote System card replacement procedures
ManB
4 0
0 0
Links_OOS: CSide 0 PSide 0 UMP OOS:0
/RG: 0
/RG: 0
Calls on RLD may be affected.
DMS-100 Family NA100 Star Remote System XPM15 and up
in an RLD
OffL CBsy
10 3
0 0
LogDrwr:
Links_OOS: 2
RLD BDch:
Do
step 8
step 9
12-135
NTTR70
(continued)
InSv
ISTb
3 3
1 1
RG
Pref 0 InSv
Stby 1 InSv
16 17
-