Nortel DMS-100 Series Maintenance Manual page 263

23 To test both units of the STAR, type
>TST PM
and press the Enter key.
If test
passes
fails, and the system produces a
card list
fails, but the system does not
produce a card list
24 The card list identifies the cards most likely to have faults. Replace the cards
one at a time in the order listed as indicated by this procedure.
If last card on list has
not been replaced
been replaced
25 To try to return the STAR to service, type
>RTS PM
and press the Enter key.
If MAP prompt indicates
RTS is sucessfull
CBsy
Load failure
All other
26 Identify the card type that was replaced.
If an NTTR77 remote controller
pack (RCP) card
was replaced
was not replaced
27 To reload the STAR, type
>LOADPM PM CC
and press the Enter key.
If load
is sucessfull
Star Remote System recovery procedures
Star Hub recovery procedure
DMS-100 Family NA100 Star Remote System XPM15 and up
Do
step 25
step 24
step 29
Do
step 30
step 25
Do
step 34
step 5
step 27
step 29
Do
step 27
step 28
Do
step 28
10-11
(continued)