Nortel DMS-100 Series Maintenance Manual page 177

The RLD level commands supported for the Star Module at the PM level are
shown in alphabetical order in the following table.
Table 6-7 Overview of RLD commands (Sheet 1 of 2)
Command Function
BSY Busy
LISTSET Lists posted set
LOADRLD_ Load remote line
drawer
NEXT Next
OFFL Offline
POST Post
QUERYRLD_ Query remote
line drawer
QUERYPES Query power and
environmental
system
QUERYCH Query Bd
channel
QUIT Quit
Star Remote System user interface 6-17
Description
Busies a posted Star Module.
Lists all Star Modules in the posted set.
Loads software and data into one bank of a posted Star
Module.
Note 1: When one bank of the Star Module needs to be
loaded, enter one of the following commands:
• LOADRLD CC to load the posted Star Module from the
computing module (CM)
• LOADRLD MATE to load the inactive bank of the posted
Star Module from its active bank.
The optional ALL parameter can be entered with the previous
commands to load all modules in a posted set that are
connected to the same STAR.
Note 2: Engineering limitation: more than 4 modules in a
posted set is not recommended.
Posts the next Star Module in a posted set.
Sets a posted Star Module offline.
Posts a specific Star Module, all Modules in a specified state,
or all Star Modules as a group.
Displays information about a posted Star Module, including
module internal number, load name from table LCMDRINV,
line maintenance unit (LMU) card status, ringer status, and
module status and physical location. Also displays
information about faults when used with the FLT option, and
information about original bank loadnames, bank status and
RLD activity when used with the CNTRS option.
Displays PES alarms for the posted Star Module.
Displays special connection information for the Bd channel.
Quits the current PM level of the MAP terminal or cancels a
Star Module selection.
DMS-100 Family NA100 Star Remote System XPM15 and up