Nortel DMS-100 Series Maintenance Manual page 178

6-18 Star Remote System user interface
Table 6-7 Overview of RLD commands (Sheet 2 of 2)
Command Function
RTS Return to service
SwBnk Switch bank
TRNSL Translate
TST Test
Module state display
At the STAR and RLD levels of the MAP display, the status of the Star
Modules are displayed below the status of the STAR units. The drawers and
Star Modules are numbered from 1 through 18. The MAP display shows the
LSGs, which are numbered 0 to 35. The LSGs are essentially one half of the
line drawer. The states of the line drawers and Star Modules are listed below
the drawer and Star Module numbers.
The codes used to display RLD (LSG) states at the MAP terminal are listed in
the following table. The state codes are standard abbreviations to describe line
drawer states.
Table 6-8 Drawer states
Code
• (dot)
I
C
M
O
S
-
297-8353-550 Standard 05.01 March 2001
Description
Returns to service a posted Star Module or its Bd channel.
Switches activity between the two loadable firmware banks of
the Star Module. When the SwBnk command is entered, the
following message is output at the MAP terminal:
WARNING: A COLD switch Bank will be
performed. All existing calls will be
dropped. Do you wish to continue?
confirm ("YES", "Y", "NO", or "N")
Displays link status and message condition for the interface
links between the Star Module and the Star Hub.
Tests the posted Star Module or its Bd channel.
Definition (abbreviation)
In service (InSv)
In-service trouble (ISTb)
C-side busy, when the host STAR is not in service
Manual busy (ManB)
Offline (OffL)
System busy (SysB)
Unequipped
Please