Nortel DMS-100 Series Maintenance Manual page 380

12-32 Star Remote System card replacement procedures
NT6X54
in a STAR
(continued)
8
9
10
11
At the SRHE frame
12
297-8353-550 Standard 05.01 March 2001
To busy both line subgroups associated with the STAR drawer where the card
is being replaced, type
>BSY DRWR
and press the Enter key.
Example of a MAP response;
Please confirm ("YES," "Y," "NO," or "N"):
To confirm the system prompt, type
>YES
and press the Enter key.
Go to step 12.
To busy both line subgroups associated with the STAR drawer where the card
is being replaced, type
>BSY DRWR lsg
and press the Enter key.
where
lsg
is one of two line subgroups (0 through 35) associated with the drawer
Example of a MAP response:
STAR REM1 00 0 Drwr 4 will be taken out of service
Please confirm ("YES," "Y," "NO," or "N"):
To confirm the system prompt, type
>YES
and press the Enter key.
Note: Repeat this step for the other line subgroups associated with the
line drawer.
Example of a MAP display:
STAR Rem1 OO O ISTb
Unit 0: InSv Mtce
Unit 1: InsV Mtce
Drwr: 11 11 11 11 11 22 22 22 22 22 33 33 33 Pref 0 InSv
01 23 45 67 89 01 23 45 67 89 01 23 45 67 89 01 23 45 Stby 1 InSv
.. .. MM .. .. .. .. .. .. .. .. .. .. .. .. .. .. ..
Remove the -48V fuse for the line drawer containing the faulty bus interface
card.
Note: The line drawer fuses are grouped and labeled as +5 V, +15 V, and
-48 V and are numbered from 1 to 18. The line drawers are numbered from
1 to 18. Any +5 V, +15 V, or -48 V fuse in position 1 is associated with line
Links_OOS: CSide 0 PSide 0
/RG: 0
/RG: 0
UMP OOS: 0
RG: