Nortel DMS-100 Series Maintenance Manual page 471

EMI card number
0
1
2
3
4 To access the line test position (LTP) level of the MAP terminal and post the
lines associated with the EMI card, type
>MAPCI;MTC;LNS;LTP;POST L site frame unit lsg ckt_range
and press the Enter key.
where
site
is the name of the site where the STAR is located
frame
is the frame number of the STAR with the faulty card
unit
is 0 for the STAR
lsg
is the number of the line subgroup with the faulty card (0-35)
ckt_range
is the range of circuits associated with the faulty card, such as 0-15 or
16-31
Example of a MAP response:
LCC PTY RNG .....LEN.........
RES REM1 00 0 03 03
5 To busy the lines, type
>BSY
and press the Enter key.
Note: The BSY command does not complete until there are no calls in the
talking state within the range of the posted lines.
At the RLD site
6 Get a replacement card with the same product equipment code (PEC),
including suffix, as the card you just removed.
7 Open the Star Module and access the TSS. Locate the EMI filter to be
replaced using the TSS diagram.
Star Remote System card replacement procedures
DMS-100 Family NA100 Star Remote System XPM15 and up
in an RLD
Line cards affected
Lower line subgroup, cards 0-15
Lower line subgroup, cards 16-31
Upper line subgroup, cards 0-15
Upper line subgroup, cards 16-31
DN STA F S LTA TE RESULT
7213355 MB
12-123
NTTR66
(continued)