Nortel DMS-100 Series Maintenance Manual page 413

13 Prepare to remove the faulty card identified in step 6 by opening the line
drawer and following these substeps.
Line cards
Line drawer
Thumb-latch button
a Face the drawer shelf and hold the handle at the bottom of the drawer
with your right hand.
b Push up on the drawer latch with your thumb and pull the drawer out until
fully withdrawn. It is fully withdrawn when the drawer stop, at the top,
prevents further travel.
c Maintain a slight pull on the handle and lift the faceplate of the drawer
approximately 2.5 cm (1.0 in.).
d While holding the drawer in this position, push the bottom of the drawer
nearest the shelf with your left hand to a position about 1.0 cm (0.5 in) to
the right.
e Hold the drawer in this position with your left hand and lower the faceplate
of the drawer by releasing the grip of your right hand.
f Make sure a card shroud and line card extractor are available.
Star Remote System card replacement procedures
DMS-100 Family NA100 Star Remote System XPM15 and up
NTEX17
in a STAR
(continued)
12-65