Nortel DMS-100 Series Maintenance Manual page 465

a Using your fingers or thumbs, push on the upper and lower edges of the
faceplate to ensure the card is fully seated in the shelf.
b Close the locking levers.
At the FSP
14 Turn ON the circuit breaker turned OFF in step 9.
15 Remove the wrist strap.
16 If you were directed to this procedure from an alarm clearing procedure in this
manual, return now to the alarm clearing procedure that directed you here.
Otherwise, continue with step 17.
At the MAP terminal
17 To return the STAR unit to service, type
>RTS UNIT unit_no
and press the Enter key.
where
unit_no
is the number of the STAR unit (0 or 1) busied in step 8
If RTS
passes
fails
18 To switch ringing generator activity to the new NTTR60 card, type
>SWRG UNIT unit_no
and press the Enter key.
where
star_unit
is the STAR unit (0 or 1) where the RG was replaced
If the SWRG command
passes
fails
19 Send any faulty cards for repair according to local procedure.
20 Record the following items in office records:
• date the card was replaced
• serial number of the card
• indications that prompted replacement of the card
Go to step 22.
Star Remote System card replacement procedures
DMS-100 Family NA100 Star Remote System XPM15 and up
in a STAR
Do
step 18
step 21
Do
step 19
step 21
12-117
NTTR60
(continued)