Nortel DMS-100 Series Maintenance Manual page 196

Star remote system

Hide thumbs Also See for DMS-100 Series:

Table of Contents

6-36 Star Remote System user interface

Table 6-17 LTPMAN level commands (Sheet 2 of 2)

DCHCON (non-menu)

Note 1: Uses external equipment.

Note 2: RLSCONN cleans up and releases the line under test and uses EOC messaging.

LTPLTA level

The following table contains a list of LTPLTA commands. LTPLTA level

commands are used to verify loop characteristics such as impedance,

capacitance, and voltage for lines connected to a Star Hub and Star Module.

When the command is supported by POTS, coin, and ISDN lines, the word All

appears in the Line types column.

Table 6-18 LTPLTA level commands (Sheet 1 of 2)

MONLTA (note 1)

TALKLTA (note 1)

VDC (and VDC C)

Note 1: MONLTA and TALKLTA are also supported for POTS and COIN lines through a pulse-code

modulation (PCM) connection, where they are not configuration dependent. The ORIG command

cannot be used with a PCM MONLTA or TALKLTA connection.

Note 2: The LMU in the Star Module only supports one metallic connection that is connected to all

64 lines. MONTALK is not supported in the LMU and therefore other commands that require the

MONTALK connection such as RING, ORIG, DGTTST, and TALKLTA are not supported.

297-8353-550 Standard 05.01 March 2001

Supported by

Star Module?

Supported by

Star Module?

Configuration

Not applicable

Configuration

Show Quick Links

Table of Contents

Troubleshooting