Nortel DMS-100 Series Maintenance Manual page 414

12-66 Star Remote System card replacement procedures
NTEX17
in a STAR
(continued)
14
297-8353-550 Standard 05.01 March 2001
DANGER
Risk of personal injury
Make sure you handle the line card carefully. The line feed
resistor can be very hot. To avoid injury, use the
insertion/withdrawal tool to remove the card as shown in the
figure that follows.
Remove the line card to be replaced by using the following substeps:
a Slide a card shroud over the card to be removed and an adjacent card. If
there is not an adjacent card on either side, do not use the card shroud.
b Hold the edge of the card with a line card extractor at a point in the center
between the top and bottom edges. Hold the extractor in your right hand.
c Squeeze the handles of the extractor together to hold the card tightly.
Insertion/withdrawal
tool