Lns Level User Interface For The Star Remote System; Ltp Level - Nortel DMS-100 Series Maintenance Manual

Table 6-13 Overview of LMU level commands (Sheet 2 of 2)
Command Function
CONVERT Convert
FRLS Forced release
HOST Host
NEXT Next
OFFL Offline
POST Post
QUERYTE Query test
equipment
QUIT Quit
RTS Return to service
TST Test

LNS level user interface for the Star Remote System

Star Remote System lines maintenance involves using commands from various
MAP levels depending on the type of testing desired or, in some cases, the type
of line to be tested. This section presents the LNS-(lines) level user interface
for Star Remote System lines maintenance.

LTP level

By using the line test position (LTP) level of the MAP terminal, the operating
company can run various tests on lines off the Star Hub and Star Module.
The "LTP level commands" table lists the commands available at the various
MAP levels for line maintenance. Each command is described in terms of
whether it is supported and whether a specific configuration is required.
Table 6-14 LTP level commands (Sheet 1 of 2)
Command
QUIT
POST
Description
Converts from external formats to NN and TN for the posted
test equipment. This command is mainly used for debugging.
Forces the release of a posted LMU and puts it in the ManB
state.
Posts an LMU or LMUs that reside in a specified host by host
identifier.
Posts the next LMU in a posted set.
Sets a posted LMU or group of LMUs offline.
Posts an LMU or group of LMUs by the LMU number.
Queries an LMU .
Quits the current TSTEQUIP level.
Returns the LMU or LMUs to service.
Performs diagnostics on an LMU card.
Line types Description
All Quits the current level.
All Places the line in the control
position.
DMS-100 Family NA100 Star Remote System XPM15 and up
Star Remote System user interface 6-31
Configuration notes
Not applicable
Not applicable