Nortel DMS-100 Series Maintenance Manual page 262

10-10 Star Remote System recovery procedures
Star Hub recovery procedure
20
21
22
297-8353-550 Standard 05.01 March 2001
(continued)
where
pm_type
is the type of host PM such as LTC, LGC, or RCC2
pm_no
is the number of the host pm_type (0 to 255)
link_no
is the number of the link connected the host PM (see the MAP display
in step 17)
Repeat the POST command for each link.
Example of a MAP response:
Host XPM P-side link number
N CLASS SITE LTC
0 REMOTE HOST 1
Note: This MAP response shows carrier facilities from the host XPM to
the STAR. The carrier facilities must also be checked from the remote site
and back to the host PM.
If link conditions show
a high number of SLIP and FRME
a very low number of SLIP and
FRME
To post the STAR with the alarm condition, type
>POST STAR site frame unit
and press the Enter key.
where
site
is the site of the STAR (alphanumeric)
frame
is the frame number of the STAR (0-511)
unit
is 0 for the STAR
To busy both units of the STAR, type
>BSY PM
and press the Enter key.
To respond to a system request for verification, type
>YES
and press the Enter key.
CK D ALRM SLIP FRME BER ES SES STATE
0 C 0
Do
Leave the STAR in ESA. Go to step
29.
step 20
0 1 0 0 INSV