Nortel DMS-100 Series Maintenance Manual page 290

11-24 Star Remote System alarm clearing procedures
PM STAR
critical
(continued)
18
19
20
21
22
297-8353-550 Standard 05.01 March 2001
Determine if the STAR has the ESA timer set for manual recovery from ESA.
Access table OFCENG by typing
>TABLE OFCENG
and pressing the Enter key.
Check the STAR exit time by typing
>POS RLCM_XPMESAEXIT
and pressing the Enter key.
Example of a MAP response:
PARMNAME
–––––––––––––––––––––––––––––––––––––––––––––
RLCM_XPMESAEXIT
If PARMVAL is
set to zero
greater than zero
Before manually restoring the STAR from ESA, check to see if links to the
STAR are stable. Find the link numbers for this STAR by typing
>TRNSL C
and pressing the Enter key.
Example of a MAP response:
Link 0: LTC 1
Link 1: LTC 1
Link 2: LTC 1
Link 3: LTC 1
Access the CARRIER level of the MAP terminal by typing
>TRKS;CARRIER
and pressing the Enter key.
Post the host XMS-based peripheral module (XPM) links and check link
conditions for slips and framing errors by typing
>POST LTC pm_no link_no
and pressing the Enter key.
where
pm_no
is the number of the LTC (0 to 255)
PARMVAL
6
Do
step 20
Allow the system to recover the
STAR. Go to step 30.
0;Cap MS;Status:OK
2;Cap MS;Status:OK
3;Cap S;Status:OK
4;Cap S;Status:OK
;MsgCon:OPN
;MsgCon:OPN