Engine Running, Header Engaged, Draper Header, Index Switch On - MacDon M105 Operator's Manual

Display (lower or upper line)
#### KNIFE SPEED
#### KNIFE SENSOR (flashing)
##.# HEADER HEIGHT
##.# HEADER SENSOR (flashing)
##.# HEADER ANGLE
##.# HEADER SENSOR (flashing)
##.# VOLTS
FUEL |■■■■|■■■■|
ENGINE TEMP ### °F
ENGINE TEMP ### °C (if metric)
SCROLL
SUB-MENU (lower line only)
#### KNIFE SPEED
##.# REEL RPM
##.# DRAPER SPEED
FUEL |■■■■|■■■■|
KNIFE SPD OVERLOAD (lower line)

Engine Running, Header Engaged, Draper Header, Index Switch ON

Scroll through display with cab display module (CDM) switch or ground speed lever (GSL) switch.
Display (lower or upper line)
#####.# ENGINE HRS
#####.# UNIT HRS
#####.# HEADER HRS
##.# ACRES/HOUR
##.# HECTARES/HOUR (if metric)
###.# SUB ACRES
###.# SUB HECTARES (if metric)
###### TOTAL ACRES
###### TOTAL HECT (if metric)
##.## ##.# REEL IND
##.## REEL.SENSOR (flashing)
##.# ##.# DRAP INDX
#### KNIFE SPEED
#### KNIFE SENSOR (flashing)
##.# HEADER HEIGHT
##.# HEADER SENSOR (flashing)
9. Optional: Available with Expansion Module installation—Whole Goods bundle MD #B4666.
169890
OPERATOR'S STATION
Description
Knife speed In strokes per minute. Optional.
Sensor Disabled.
Distance setting (00.0–10.0) between cutterbar and ground.
Sensor Disabled.
Header Angle setting (00.0–10.0) relative to ground. Optional.
Sensor Disabled. ANGLE and SENSOR alternate at 1 second intervals.
Engine electrical system operating voltage.
Level of fuel in tank.
Engine coolant temperature.
Displays sub-menu after 2–3 seconds. Press SELECT to cancel.
Scroll through sub-menu display with CDM switch.
Optional.
8
Knife speed is less than programmed set point.
Description
Total engine operating time.
Total windrower operating time.
Total header operating time.
Actual cutting rate in acres (hectares)/hour.
Area cut since last reset. To reset, display SUB ACRES on lower line
and hold down program switch until display resets (5–7 Seconds).
Total area cut by machine.
Reel peripheral speed along with ground speed in mph or kph.
Optional.
9
Sensor Disabled.
Draper speed along with ground speed in mph or kph.
Knife speed in strokes per minute. Optional
Sensor Disabled.
Distance setting (00.0–10.0) between cutterbar and ground.
Sensor Disabled.
65
8
8
9
Revision A