MacDon M105 Operator's Manual page 324

Installing Forked Caster Wheel
1. Position wheel assembly (C) on axle assembly (B) and
install wheel nuts (A).
2. Torque wheel nuts (A). Refer to
Wheel Nuts, page 306.
3. Position wheel assembly (D) in forked caster (E).
4. Position cover plates (C) and install eight bolts (A) (four
on each side of caster) to secure axle (B) to caster (E).
Torque bolts to 75–79 ft·lbf (97–107 N·m).
5. Lower caster wheel. Refer to
(Formed and Forked), page
Removing Formed Caster Wheel
1. Raise caster wheel. Refer to
(Formed and Forked) , page
2. Remove the six bolts (A) that secure the wheel (B) to
the hub.
3. Remove wheel (B).
169890
MAINTENANCE AND SERVICING
Tightening Caster
Lowering Caster Wheel
309.
Raising Caster Wheel
308.
310
Figure 5.211: Caster Wheel Assembly
Figure 5.212: Caster Wheel Assembly
Figure 5.213: Caster Wheel Assembly
Revision A