MacDon M105 Operator's Manual page 175

5. Remove hairpin from the clevis pin (A) and remove the
clevis pin from left and right header boots (B).
6. Lower the stand (A) by pulling clevis pin (B), inverting
stand, and relocating on bracket. Reinsert pin (B) and
secure with hairpin.
7. Remove the clevis pin from linkage (A) to disengage
float springs and insert in storage hole (B). Secure with
lynch pin. Repeat for opposite linkage.
CAUTION
To prevent damage to the lift system when lowering
header lift linkages without a header or weight box
attached to windrower, ensure that float engagement
pin is installed in storage location (B) and NOT
installed at hole location (A).
169890
OPERATION
Figure 4.153: Header Boot
Figure 4.154: Header Stand
Figure 4.155: Header Lift Linkage
161
Revision A