Closing Platform (Major Service Position) - MacDon M105 Operator's Manual

4. Remove the nut and bolt that secures the link (A) to the
frame. Swing link (A) out of the way.
5. Pull the front (cab-forward) end of platform away from
frame while moving it towards the walking beam. Aft
corner (B) of platform should project slightly into engine
bay when optimum opening is reached.

5.5.4 Closing Platform (Major Service Position)

CAUTION
Do NOT stand on the platform in the unlocked position. It is unstable and may result in a fall.
1. Swing link (A) all the way forward.
2. Push the front (cab-forward) end of platform towards
the frame while moving the platform forward
(cab-forward).
3. Position link (A) on bracket and install bolt and nut.
Tighten enough so that link can still swivel on bracket.
4. Move platform (B) forward (cab-forward) until it stops
and latch (A) engages.
5. Close the hood. Refer to
Position), page 203.
169890
MAINTENANCE AND SERVICING
5.4.2 Closing Hood (Lower
Figure 5.26: Platforms
Figure 5.27: Platforms
Figure 5.28: Platform Latch
208
Revision A