Air Intake System - MacDon M105 Operator's Manual

3. Remove filler cap (A) by turning it counterclockwise.
4. Carefully pour the oil. A funnel is recommended to
avoid spillage. Refer to
Capacities, page 199
CAUTION
Do NOT fill above the HIGH mark.
5. Replace oil filler cap (A) and turn it clockwise until snug.
6. Check the oil level. Refer to
page 227.
7. Close the hood. Refer to
Position), page 203.

Air Intake System

IMPORTANT:
Do NOT run engine with air cleaner disconnected or disassembled.
Engine intake air is drawn through a duct (A) from the
cooling box that precleans the air and then through a dual
element filter (B).
The air cleaner canister
aspirator (C) that removes dust continuously from the air
cleaner housing.
The air cleaner is also equipped with an air filter restriction
switch (D) that indicates when the primary filter element
requires cleaning.
Refer to
Filter Part Numbers, page
IMPORTANT:
• Do NOT run engine with air cleaner disconnected or
disassembled.
• Over-servicing the filter element increases the risk
of dirt being ingested by the engine and severely
damaging the engine.
• Filter servicing should only be performed when
the CDM indicates "ENGINE AIR FILTER" or
at the specified interval.
Schedule/Record, page
169890
MAINTENANCE AND SERVICING
Lubricants, Fluids, and System
for oil specifications.
Checking Engine Oil Level,
5.4.2 Closing Hood (Lower
is equipped with
200.
Refer to
Maintenance
315.
Figure 5.64: Oil Filler Cap
an
Figure 5.65: Air Intake System
230
Revision A