MacDon M105 Operator's Manual page 288

3. Remove grommet (A) from light support (B).
4. If replacing lamp and bracket assembly, remove nut (C)
and spring washer from inside light support (B) and
remove light assembly.
5. If replacing the lamp only, remove the nut, spring
washer and bolt (A) securing lamp (B) to lamp
bracket (C) and remove lamp (B).
6. If installing lamp only, position new lamp (B) in lamp
bracket (C) and secure with bolt (A), spring washer and
nut. Adjust lamp (B) to desired position and tighten
bolt (A).
7. If installing light/bracket assembly, locate light in center
hole in light support (B) and secure with hardware (C)
provided with light assembly. Adjust light assembly to
desired position and tighten nut (C).
8. Route lamp harness through grommet (A) and slot in
light support (B).
9. Reinstall grommet (A) in light support (B).
169890
MAINTENANCE AND SERVICING
274
Figure 5.146: HID Light Assembly
Figure 5.147: HID Auxiliary Lights
Figure 5.148: HID Light Assembly
Revision A