MacDon M105 Operator's Manual page 179

6. Lower the header stand (A) by pulling clevis pin (B),
inverting stand, and relocating on bracket. Reinsert
clevis pin (B) and secure with hairpin.
7. Remove clevis pin from linkage (A) to disengage float
springs and insert in storage hole (B). Secure with
lynch pin. Repeat for opposite linkage.
CAUTION
To prevent damage to the lift system when lowering
header lift linkages without a header or weight box
attached to windrower, ensure that float engagement
pin is installed in storage location (B) and NOT
installed at hole location (A).
8. To disengage safety props and for storage, turn
lever (A) away from header to raise safety prop
until lever locks into vertical position.
opposite cylinder.
9. Start engine, choose a level area, and lower header
to ground.
10. Stop engine and remove key from ignition.
169890
OPERATION
Figure 4.164: Header Stands
Figure 4.165: Header Lift Linkage
Repeat for
Figure 4.166: Safety Prop
165
Revision A