Using Return To Cut Feature - MacDon M105 Operator's Manual

Using Return to Cut Feature

Figure 4.77: Operator Console
A - Return to Cut
D - Display
Use the RETURN TO CUT feature as follows:
IMPORTANT:
Ensure the header is engaged and the RETURN TO CUT switch (A) is illuminated.
NOTE:
The header can be raised or lowered by pressing and holding the HEADER UP (B) or HEADER DOWN (C)
switches on the ground speed lever (GSL).
1. If header is above the preset cutting height, momentarily press HEADER DOWN switch (C) and the header
will return to preset height.
2. If the header is below the preset height, press and hold the HEADER UP (B) switch to raise the header. Release
switch to stop header. Alarm will sound when header rises past the preset height.
3. If the header angle changes (for machines equipped with optional hydraulic center-link and expansion module),
double-click (two clicks within 0.5 seconds) the HEADER TILT UP (E) or HEADER TILT DOWN switch (F) and
the header will return to the preset angle.
NOTE:
If the header cannot return to the preset height or angle within 30 seconds, the RETURN TO CUT feature will
deactivate to prevent the hydraulic oil from overheating. Push the RETURN TO CUT switch (A) to reactivate.
169890
OPERATION
B - Header Up
E - Header Tilt Up
129
C - Header Down
F - Header Tilt Down
Revision A