Auger Speed On A40-D Headers - MacDon M105 Operator's Manual

Auger speed NOT to exceed 320 rpm.

Auger Speed on A40-D Headers

On A40-D double knife headers, the auger speed is interdependent on reel speed, and is controlled by a switch on
the ground speed lever (GSL).
Figure 4.188: Operator Console
A - Display
D - Auger Slow
CAUTION
Check to be sure all bystanders have cleared the area.
Change auger speed as follows:
1. Engage header.
2. Set HEADER INDEX switch (B) to OFF
3. On ground speed lever (GSL), press DISPLAY SELECTOR switch (E) until ##.# AUGER SPEED is displayed
Display (A) shows ##.# AUGER SPEED
##.# = 4.7 to 9.9
4. Press FAST (C) or SLOW (D) on CDM until desired auger speed is displayed at (A).
16. Auger speed not to exceed 320 rpm.
169890
OPERATION
B - Header Index Switch
E - Display Selector
.
16
180
C - Auger Fast
D - Auger Slow
Revision A